新闻资讯

The principle of engraving machine lettering How is the engraving machine engraved?

2019-06-24


At present, the cutting plotter has been widely used in advertising, exhibition, decoration and other industries. So, how is the cutting plotter engraved?
 
First of all, here is a quick note (sticker). Sticky notes are the most commonly used lettering materials. It consists of two layers of material, the surface layer and the backing. The front of the surface is of various colors, without glue or tackiness; the back of the surface is covered with glue, which has different adhesion to different materials. The backing is non-adhesive and has a smooth texture. It is attached to the back of the surface, but the adhesion is small. It is easy to separate the backing of the sticky note from the back of the surface with fingers. The engraving software uses the computer to drive the plotter action, and uses the cutter head on the plotter to engrave the characters and graphics you want on the sticky notes.
 
The length of the tip can be adjusted. So, how long should the length of the tip be adjusted? It is easy to see that the length of the ideal tip should be adjusted to be greater than the thickness of the surface layer of the instant sticker and less than the thickness of the surface layer + backing. Since the seat itself has a sheath-protected sheath, the surface layer that is not dry can be cut and the backing is not cut. Therefore, the length of the tip should not be too short, and it should not be too long. (If it is too long, the knife must be adjusted to a suitable size. Otherwise, the backing will be cut. If it is too short, it will not be cut.) If the tip is too long, it will be created. Will cause no cut), too long a knife tip will cause the cutting machine bead damage, and even the tip of the knife will break.

Relative News