新闻资讯

The principle of engraving machine lettering How is the engraving machine engraved?

2019-06-24


At present, the cutting plotter has been widely used in advertising, exhibition, decoration and other industries. So, how is the cutting plotter engraved?
 
First of all, here is a quick note (sticker). Sticky notes are the most commonly used lettering materials. It consists of two layers of material, the surface layer and the backing. The front of the surface is of various colors, without glue or tackiness; the back of the surface is covered with glue, which has different adhesion to different materials. The backing is non-adhesive and has a smooth texture. It is attached to the back of the surface, but the adhesion is small. It is easy to separate the backing of the sticky note from the back of the surface with fingers. The engraving software uses the computer to drive the plotter action, and uses the cutter head on the plotter to engrave the characters and graphics you want on the sticky notes.
 
The length of the tip can be adjusted. So, how long should the length of the tip be adjusted? It is easy to see that the length of the ideal tip should be adjusted to be greater than the thickness of the surface layer of the instant sticker and less than the thickness of the surface layer + backing. Since the seat itself has a sheath-protected sheath, the surface layer that is not dry can be cut and the backing is not cut. Therefore, the length of the tip should not be too short, and it should not be too long. (If it is too long, the knife must be adjusted to a suitable size. Otherwise, the backing will be cut. If it is too short, it will not be cut.) If the tip is too long, it will be created. Will cause no cut), too long a knife tip will cause the cutting machine bead damage, and even the tip of the knife will break.

Relative News


New Arrival | The real Auto Digital Rear Cut is coming!

"For such a long time, we do the package diecut and crease with printing the mark points in Digital packaging industry  , and then by scanning marked points in front of the materials to get the contour line for creasing and cutting, especially the procedure with creasing/indentation, it is inevitable damage the media, often occur with irregular line and Critical edge, not even mention the display, For High standard packaging requirements are more unacceptable.Besides, the traditional indentation process is through the back of the operation, which has been the weakness of digital die cutting for indentation , so we want to solve this, to achieve the whole process fully automaticly, and we're honored, we made it." -- Senior Manager of Product Development of SAGA ASF420 a digital auto die-cutting equipment that integrates paper feeding/scanning creasing and cutting systems. Based on the company's AFC series, many details have been optimized, but it is far from a self-feeding digital flatbed cutting machine. Subversive innovations have been made in output software, control system, tool selection, and sweep mode. The scanning and running speed are greatly improved as well as the down force can be up to 1900g, and the rear creasing + die-cutting is perfectly realized.It's the best choice for all packaging company and assistance for after printing industry.  1: Digital die-cutting crafts which meet mass production process standard 2: More intelligent interaction with 7-inch touch screen 3:4 tools in 4 combinations 4:Automatic induction lifting feeder combined with independent paper feeding system  5:Feeding, REAR scanning and REAR cutting separately with non-interference 6:Wider application scenarios with wider format and thicker material 7: More medias can be placed up to 18 CM stacking  8:The speed are greatly improved both on scanning and running

View detail